With the newest mannequin of the R&S FSPN part noise analyzer and VCO tester, Rohde & Schwarz extends the frequency vary for measurements from the earlier most of 26.5 GHz as much as 50 GHz.
By rigorously implementing capabilities strictly for part noise evaluation and voltage-controlled oscillator (VCO) measurements, Rohde & Schwarz gives a wonderful price-to-performance ratio with all R&S FSPN fashions. The R&S FSPN gives each excessive velocity measurements and in addition accuracy for characterizing sources comparable to synthesizers, VCOs, OCXOs and DROs. Since a trade-off between growing velocity of check and better accuracy is inevitable, customers can select the setting finest suiting their software. This makes the R&S FSPN a super answer not just for manufacturing check, but in addition for a lot of oscillator growth necessities.
The brand new R&S FSPN50 covers the frequency vary from 1 MHz to 50 GHz and enhances the prevailing 8 and 26.5 GHz fashions. For engineers each creating and producing top quality oscillators, the R&S FSPN50 helps functions within the Ka band from 26.5 to 40 GHz, and within the Q band (36 to 46 GHz) and within the decrease V band as much as 50 GHz. Typical functions at these frequencies embody industrial point-to-point wi-fi and microwave communication methods, satellite tv for pc communications together with excessive throughput satellite tv for pc companies, army satellite tv for pc and communication methods working as much as 50 GHz, close-range focusing on radars, and virtually your entire 5G FR2 frequency vary from 21.84 GHz to 50.20 GHz.
The wonderful part noise sensitivity of the R&S FSPN relies on two low noise inner native oscillators enabling real-time cross correlation. The person can improve the variety of correlations for greater accuracy or scale back them for greater velocity. The present cross-correlation sensitivity achieve is proven in real-time along with the present end result hint. Part noise and amplitude noise are measured individually and concurrently, offering each a wonderful evaluation of part noise efficiency, and a direct route for figuring out the reason for any issues, with none compromise in measurement velocity. Correct VCO measurements are enabled by three low-noise DC sources. OCXO and DRO applied sciences in addition to VCO can all be measured. For straightforward distant management and manufacturing automation, sequences of SCPI instructions may be recorded mechanically.
The brand new R&S FSPN50 part noise analyzer and VCO tester as much as 50 GHz is now accessible from Rohde & Schwarz. For additional data, go to: https://www.rohde-schwarz.com/product/FSPN